Elegant home with power saving, security, safety, remote controlling and auto control of water tank motor
The main aim of this project is provide security, safety and automation for homes and offices. These are very essential in present life style.
Security is primary concern for every one. This Project describes a design of effective security alarm system that can monitor the house with eight different sensors. Unauthorized access, Fire accident, wall braking, IR detection, and fire detection can be monitored by the status of each individual sensor and is indicated with an LED.
The burglar alarm is built around the AT89C51 micro controller from Atmel. This micro controller provides all the functionality of the burglar alarm. A maximum of 8 sensors can be connected to the burglar alarm. A power supply voltage of +5 VDC is available for each sensor at the corresponding wiring terminals.
LEDs indicate the status of the corresponding sensors. When the alarm has been activated, the LED of the sensor that caused the alarm will light up, or flash in the event of a cable failure.
Apart from security concern here we also take care of home automation. In this competitive world human cannot spare his time to perform his daily activities manually without any fail. The most important thing he forgets is to switch off the room lights wherever not required. With this, even the power will be wasted up to some extent. This project gives the best solution for electrical power wastage. Also the manual operation is completely eliminated. The home appliances can be switched on/off using IR without actually going near the switch boards or regulators. The TV remote used in this project is IR remote.
The loads like lights, motors, heaters, power controlling system and also current through the loads can be controlled in this project. We can control all loads at a time from one place (control room) without connecting any physical wire between loads and control room.
The water level of the water tank can also be monitored and the motor can be controlled through project. Due to which we can save wastage of both the water and electricity
This project uses regulated 5V, 500mA power supply. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac out put of secondary of 230/12V step down transformer.
SOFTWARE AND HARDWARE TOOLS:
- Keil compiler
- IR SENSOR
- WATER LEVEL SENSOR